Dimming The Lights with remote controller, device Ir Light Dimmer, has got a new and simplest version. The most significant change is microcontroller PIC12F629 in Small-Outline Integrated Circuit (SOIC) package, TSOP2238 ir receiver instead of TSOP1738, and less components on circuit board.source
Remote control circuits
Ir Light Dimmer
Radio Remote Control using DTMF
Here is a circuit of a remote control unit which makes use of the radio frequency signals to control various electrical appliances. This remote control unit has 4 channels which can be easily extended to 12. This circuit differs from similar circuits in view of its simplicity and a totally different concept of generating the control signals. Usually remote control circuits make use of infrared light to transmit control signals. Their use is thus limited to a very confined area and line-of-sight.source
Sensitive Modulated Light Receiver with CD4069
The circuit uses a very inexpensive C-MOS IC that is connected to a small photodiode. Using a unique inductive feedback network, the circuit provides high sensitivity under high ambient light conditions. It is a great circuit when you want to extend the range of an optical remote control transmitter.source
Infrared circuits for remote control
These circuits are used to transmit a 1-4 kHz digital signal (OOK modulation) through infra light (this is the maximum attainable speed, 1000-4000 bits per sec). The transmitter oscillator runs with adjustable frequency in the 32-56kHz range, and is being turned ON/OFF with the modulating signal, a TTL voltage on the MOD input. On the receiver side a photodiode takes up the signal. The integrated circuit inside the chip is sensitive only around a specified frequency in the 32-56 kHz range. This Infrared remote controls are using a 32-56 kHz modulated square wave for communication.source
Serial port controlled infrared transmitter with PICMicro
This is a programmable infrared (remote control) transmitter, which can be controlled from a PC serial port. It is capable of sending many remote control formats, including the Philips RC-5 standard.The controller will accept commands on the serial port. Settings are: 19200 bps, 8 bits, no parity, 1 stopbit, no flow control (XON/XOFF or RTS/CTS). Commands consist of hex coded bytes and must be written on the port as ASCII characters separated by space, terminated by ENTER (ASCII char 0d) source
Online Tools
Sponsored Links
What Circuits ?
-
- Alarm and Security
- Audio / Signal Processing
- Audio circuits
- Automotive
- Battery charger circuits
- Communication
- Computer related circuits
- Controller
- Display related circuits
- Electronic switch circuits
- Encoder and Decoder
- Fun circuits
- How to and Ideas
- Input/Output circuits
- Instruments Circuits
- Laser related circuits
- LED circuits
- Light control circuits
- Microcontroller
- Motor control circuits
- Power supply circuits
- Remote control circuits
- RF circuits
- Sensor circuits
- Signal generator circuits
- Software
- Sound and Music circuits
- Telephone circuits
- Temperature related circuits
- Timer/Counter circuits
- Uncategorized
- Video circuits
