Dimming The Lights with remote controller, device Ir Light Dimmer, has got a new and simplest version. The most significant change is microcontroller PIC12F629 in Small-Outline Integrated Circuit (SOIC) package, TSOP2238 ir receiver instead of TSOP1738, and less components on circuit board. [...]

These circuits are used to transmit a 1-4 kHz digital signal (OOK modulation) through infra light (this is the maximum attainable speed, 1000-4000 bits per sec). The transmitter oscillator runs with adjustable frequency in the 32-56kHz range, and is being turned ON/OFF with the modulating signal, a TTL voltage on the MOD input. On the receiver side a photodiode takes up the signal. The integrated circuit inside the chip is sensitive only around a specified frequency in the 32-56 kHz range. This Infrared remote controls are using a 32-56 kHz modulated square wave for communication. [...]

This is a programmable infrared (remote control) transmitter, which can be controlled from a PC serial port. It is capable of sending many remote control formats, including the Philips RC-5 standard.The controller will accept commands on the serial port. Settings are: 19200 bps, 8 bits, no parity, 1 stopbit, no flow control (XON/XOFF or RTS/CTS). Commands consist of hex coded bytes and must be written on the port as ASCII characters separated by space, terminated by ENTER (ASCII char 0d) [...]

This is a general purpose remote control project with using programmable PIC microcontrollers. Schematics are shown for using infrared (IR) or radio (RF) media. If you are not familiar with microcontroller programming, you can use fixed encoder and decoder integrated circuits instead. Well-known such IC-s are Holtek HT-12D, HT-12E and Motorola MC145026, MC145027, MC145028. [...]

This is a simple IR receiver circuit which plugs into a serial port of a computer. Okay, there are many other circuits of this kind, and most of them are even simpler, but this circuit has two major advantages: (1) it uses an Atmel AVR RISC microcontroller (an AT90S2313) instead of the usual PIC microcontroller and (2) it uses a Maxim MAX232 for the generation of valid RS232 levels. [...]